Separate volume controls are usually installed in each room or zone to compensate for differences in apparent volume due to room size and shape. Here especially, impedance-matching volume controls can be used to protect the amplifier from overload. This system design is otherwise the same as a single source, single zone in that all zones must listen to the same audio source, though volume control is independent in each room (and audio can be turned off in rooms, as desired).

These systems distribute the same audio source everywhere – individual rooms must listen to the same audio source. This is the simplest type of system that can be installed. If designed properly, no special equipment is required other than one amplifier and a desired audio source. Care must be taken not to overload the amplifier by keeping the total speaker impedance above the amplifier’s rated minimum impedance.

These systems are the most advanced and flexible, and the most expensive. Different zones can select (and often control) different audio sources independently of other rooms. In contrast to the systems described above, this kind requires multiple amplifiers (at least one per source, but usually one per zone). This kind of system could be assembled from separate components (e.g. a splitter-router-matrix mixer, a processor, amplifiers.